Locks
Locking and unlocking
You can use the power door lock control or the remote control to lock and unlock the vehicle.
Power Door Locks
The power door lock control is located on the driver and front passenger door panels.
Remote Control
You can use the remote control anytime the vehicle is not running.
Unlocking the Doors (Two-Stage Unlock)
Press the button to unlock the driver door.
Press the button again within three seconds to unlock all doors.
The turn signals will flash.
Press and hold both the lock and unlock buttons on the remote control for four seconds to disable or enable two-stage unlocking. Disabling two-stage unlocking allows all vehicle doors to unlock with one press of the button. The turn signals will flash twice to indicate the unlocking mode was changed. The unlocking mode applies to the remote control, keyless entry keypad and intelligent access.
Intelligent access at the driver door unlocks all doors when you have disabled two-stage unlocking.
Locking the Doors
Press the button to lock all the doors. The turn signals will illuminate.
Press the button again within three seconds to confirm that all the doors are closed. The doors will lock again, the horn will sound and the turn signals will illuminate if all the doors and the luggage compartment are closed.
Note: If any door or the luggage compartment is open, or if the hood is open on vehicles equipped with an anti-theft alarm or remote start, the horn will sound twice and the lamps will not flash.
Power Liftgate (If Equipped)
WARNING: Make sure all persons are clear of the liftgate area before using power liftgate control.
WARNING: Make sure the liftgate is closed to prevent exhaust fumes from being drawn into the vehicle. This will also prevent passengers and cargo from falling out. If you must drive with the liftgate open, keep the vents open so outside air comes into the vehicle.
Note: Be careful when opening or closing the liftgate in a garage or other enclosed area to avoid damaging the liftgate.
Press twice within three seconds to open or close the liftgate, or to reverse the movement.
Activating Intelligent Access (If Equipped)
The intelligent access key must be within 3 feet (1 meter) of your vehicle.
At the Front Doors
Pull a front exterior door handle. The door will unlock and can be opened.
Press and hold the door handle lock sensor to lock your vehicle. To avoid unlocking the door inadvertently, be sure to only touch the lock sensor and not other areas of the door handle.
At the Liftgate
Press the exterior liftgate release button on the top of the liftgate pull-cup handle.
Smart Unlocks for Integrated Keyhead Transmitter
This feature helps to prevent you from locking yourself out of your vehicle if your key is still in the ignition.
When you open one of the front doors and lock your vehicle with the power door lock control, all the doors will lock then unlock if your key is still in the ignition.
You can still lock your vehicle with the key in the ignition using the keyless entry keypad with the driver door closed, or by pressing the lock button on the transmitter even if the doors are not closed.
If both front doors are closed, you can lock your vehicle by any method, regardless of whether the key is in the ignition or not.
Smart Unlocks for Intelligent Access Keys (If Equipped)
This feature helps to prevent you from unintentionally locking your intelligent access key inside your vehicle’s passenger compartment or rear cargo area.
When you lock your vehicle using the driver or passenger power door lock control (with the door open, transmission in P and ignition off), after you close the door your vehicle will search for an intelligent access key in the passenger compartment. All the doors will immediately unlock and the horn will sound if the vehicle detects an intelligent access key inside.
In order to override the smart unlock feature and intentionally lock the intelligent access key inside your vehicle, do one of the following:
• Lock your vehicle with the keyless entry keypad after all doors are closed.
• Press the lock button on another intelligent access key.
• Touch the locking area on the handle with another intelligent access key in your
hand.
When you open one of the front doors and lock your vehicle using the power door lock control, all doors will lock then unlock if:
• the ignition is on, or
• the ignition is off and the transmission is not in P.
Autolock Feature (If Enabled)
The autolock feature will lock all the doors when:
• all the doors are closed,
• the ignition is on,
• you shift into any gear putting your vehicle in motion, and
• your vehicle reaches a speed greater than 12 mph (20 km/h).
The autolock feature repeats when:
• you open then close any door while the ignition is on and the vehicle speed
is 9 mph (15 km/h) or lower, and
• your vehicle then reaches a speed greater than 12 mph (20 km/h).
Autounlock Feature (If Enabled)
The autounlock feature will unlock all the doors when:
• the ignition is on, all the doors are closed, and your vehicle has been in
motion at a speed greater than 12 mph (20 km/h);
• your vehicle has then come to a stop and the ignition is switched off or to accessory;
and
• the driver door is opened within 10 minutes of the ignition being switched off
or to accessory.
Note: The doors will not autounlock if you electronically lock the vehicle after you switch the ignition off and before you open the driver door.
Deactivating or Activating
Note: You can activate or deactivate the autolock and autounlock features independently of each other.
You can activate or deactivate these features:
• through an authorized dealer
• using the information display (if equipped with this feature).
Illuminated Entry
The interior lamps, parking lamps and puddle lamps illuminate when you use the integrated keyhead transmitter, intelligent access key or the keyless entry keypad to unlock the vehicle.
The system will turn off the lights if:
• you switch the ignition on
• you press the lock button on the remote control
• you lock your vehicle using the keyless entry keypad
• after 25 seconds of illumination.
The lights will not turn off if:
• you turn them on with the dimmer control
• any door is open.
Illuminated Exit
The interior lamps and select exterior lamps illuminate when all doors are closed, the ignition is turned off and the key is removed from the ignition (integrated keyhead transmitter only).
The lamps turn off if all the doors remain closed and:
• 25 seconds elapse
• you insert the key in the ignition (integrated keyhead transmitter only)
• you press the START/STOP button (intelligent access key only).
Battery Saver
If you leave the courtesy lamps, dome lamps or headlamps on, the battery saver shuts them off 10 minutes after you switch the ignition off.
Accessory Mode Battery Saver for Intelligent Access Keys (If Equipped)
If you shut off the engine and leave the ignition in the on or accessory mode, the ignition will shut off after 30 minutes.
See also:
Ford ESP Extended Service Plans (Canada Only)
You can get more protection for your vehicle by purchasing a Ford Extended Service
Plan (ESP). Ford ESP is the only service contract backed by Ford Motor Company of
Canada, Limited. Depending on t ...
Safety belt height adjustment
WARNING: Position the safety belt height adjusters so that the belt rests
across the middle of your shoulder. Failure to adjust the safety belt properly could
reduce the effectiveness of the seat ...
Information messages
See Information Messages later in this chapter for more information.
Information Display Controls (Type 2)
• Press the up and down arrow buttons to scroll through and highlight the options
wit ...