Rear seats
WARNING: To prevent possible damage to the seat or safety belts, make sure that the safety belts are not buckled when folding the seat back.
• Recline seat back: With the seat occupied, pull the lever up to recline the
seat back.
• Fold seat back: With the seat empty, pull the lever up to fold the seat back forward.
• Unfold seat back: Rotate the seat back upward until the seat back latches in the
upright position. The seat back will click when it is locked into position.
EasyFold® Folding Seat (If Equipped)
WARNING: Make sure that the seat is unoccupied when folding it down. Folding the seat while occupied could result in damage to the seat or injury.
Note: The power feature is operational when the vehicle is in position P and the liftgate has been open for less than 10 minutes.
The controls are located on the left-hand rear quarter trim panel (accessible from the liftgate area).
• Fold seat back: Press and hold the control mechanism to lower the seat back.
The top portion lowers the right (40%) seat back, and the bottom portion lowers
the left (60%) seat back.
• Unfold seat back: Rotate the seat back upward until the seat back latches in the
upright position. The seat back will click when it is locked into position.
REAR SEAT ARMREST
Press the latch and pull the armrest forward for armrest or cupholder use.
Lift up one of the slotted areas on the cover to access the cup holders.
To close the armrest, close the cupholder cover and rotate the armrest rearward until the latch clicks.
See also:
Reporting safety defects (Canada only)
If you believe that your vehicle has a defect which could cause a crash or could
cause injury or death, you should immediately inform Transport Canada, using their
toll-free number: 1–800–333â ...
Transmission code designation
You can find a transmission code on the Safety Compliance Certification Label.
The following table tells you which transmission each code represents.
...
Capacities and Specifications
Engine specifications
Engine drivebelt routing
3.5L/3.7L V6 engine
1. Short drivebelt is on first pulley groove closest to engine.
2. Long drivebelt is on second pulley groove farthest from ...