Memory function
This memory control, located on the driver’s door, allows automatic positioning of the driver seat, power mirrors, steering column (if equipped) and power adjustable foot pedals (if equipped) to three programmable positions.
Programming a memory position
Note: You can program a memory position at any time.
• To program position 1, move the memory features to the desired positions using
the associated controls. Press and hold button 1 for at least two seconds. A chime
will sound confirming that a memory position has been set.
• To program position 2 and 3, repeat the previous procedure using the respective
buttons.
Recalling a memory position
You can recall a programmed memory position:
• in any gearshift position if the ignition is not on.
• only in position P or N if the ignition is on.
Press the desired memory control to recall a memory position.
Recalling memory positions with the remote control
You can recall memory positions when you press unlock on your remote control (if the transmitter is programmed to a memory position) or, when you enter a valid personal entry code that is programmed to a memory position. If the easy entry feature is enabled, the seat will first move to the easy entry position. The seat will move to the final position when the key is in the ignition or when the push button start system (if equipped) is put in accessory mode or started.
To program the memory feature to a remote control, see the Keys and Remote Control chapter.
Easy Entry and Exit Feature (If Equipped)
This feature automatically moves the driver’s seat rearward 2 inches (5 centimeters) when:
• the transmission is in position N or P
• the key is removed from the ignition or the push button start system (if equipped)
is switched off.
The seat will move to the original position when:
• the transmission is in position N or P
• the key is placed in the ignition or when the push button start system (if equipped)
is put in accessory mode or started.
The easy entry feature can be turned off or on through the information display.
See also:
Front fog lamps
The fog lamps can be turned on when the lighting control is in the headlamps,
parking lamps or autolamps positions and the high beams are not turned on. ...
Ignition switch
Note: Do not store the key in the ignition after the vehicle is turned
off and you have left the vehicle. This could cause a drain on the battery.
Note: In order to switch off the engine while the ...
Overhead console
The appearance of the overhead console will vary according to your option package.
Press near the rear edge of the door to open it. ...